![]() ![]() Reconnect the drive to the port that is configured as None or Not-Installed. This will tell the BIOS that there is no device or drive attached to the port. Set the BIOS parameters (example: Primary Master, Primary Slave, Secondary Master, or Secondary Slave) to where the drive is connected from Auto-Detect to None or Not-Installed. If there is data on the drive, please format the drive or use SeaTools for DOS' Zero-Fill utility.įollow the steps below to ensure that the Set Capacity operation is properly run: Changing a drive size to a smaller capacity is a data-destructive process. If your hard drive is seen in the BIOS as 137GB and you are installing Windows 2000 with Service Pack 3 or greater, Windows XP with Service Pack 1 or greater, or Windows Vista, you shouldn't need to set the hard drive size, as the current versions of those operating systems should bypass any BIOS limitations on the driveĭo not try to resize a drive that has data on it. Because of this, the Set Capacity feature will not work on any SATA hard drive. If you are using a SATA drive, you do not need to change what capacity is reported to the BIOS, as the specifications for SATA controllers were designed with larger-capacity drives in mind. The BIOS on the ATA PCI card should recognize the full capacity of the drive. If you are using an add-on ATA PCI adapter card, do not use this utility. ![]() This procedure applies only to ATA drives connected directly to the motherboard. Instead, it is highly recommended you either update your system's BIOS or purchase an ATA PCI controller card to bypass your system's BIOS. Please be aware that the "Set Hard Drive Size" feature is no longer available in the current versions of MaxBlast and DiscWizard, so you will have to use SeaTools for DOS instead to set the hard drive's capacity.įollowing this procedure will allow you to access your hard drive however you won't be able to use the full capacity. The feature allows older systems with a BIOS limitation to boot with the drive in the system instead of locking up or freezing during the boot process. There is no interpretation of the failure codes as they do not indicate a type of failure, just that the drive has failed to complete the diagnostic successfully.The ability to "Set Capacity" is a feature in SeaTools for DOS that will instruct the selected hard drive to report a size smaller than its true capacity during boot. If the drive continues to report a failure on the USB or Firewire port then refer the warranty services page to determine if the drive is within the warranty period and start the return process.įreeAgent Pro drives can give false diagnostic failures when tested using the FreeAgent Tools and connected via the eSATA interface. ![]() If you are testing a drive on MacOS then Firewire and USB tests should be reliable, but eSATA errors should be retested on FireWire or USB. If the drive continues to report a failure on the USB port then see the warranty services page to determine if the drive is within the warranty period and start the return process. Some eSATA and Firewire ports can block the diagnostic test and report a false failure. If you are testing a drive in a Windows based computer, be sure the drive is connected to the system via USB. If the suggestion is to exchange the drive, please see the warranty services page to determine if the drive is within the warranty period and start the return process. ![]() SeaTools will often provide suggestions based on the type of failure diagnostic during testing, follow those suggestions. If that software has produced a diagnostic code, see the steps below. Seagate Manager, Maxtor Manager, OneTouch Manager, and SeaTools have diagnostic software built into the program that can test the functionally of the drive. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |